Superyard XT - Model 8666 (manual
can be used for Pet Yard XT)
Superyard XT - Model 8666 (manual
can be used for Pet Yard XT)
Thank you for purchasing our Superyard XT. Your Superyard XT is a second generation product that represents years of engineering and product improvements, many of which were recommended by customers such as yourself. Please take a few minutes to read and follow the instructions and warning statements. In so doing, your Superyard XT should provide you with years of safe, reliable service.
Please feel free to call or write with any comments or suggestions you may have, and thanks again for your patronage.
NORTH STATES INDUSTRIES,
INC.
1507 92nd Lane NE, Blaine, MN 55449
Phone: (763) 486-1754 - Fax: (763) 486-1763
www.northstatesind.com
Parts Diagram
|
|
 |
 |
Important: Please remove all parts from the carton and review the parts diagram to familiarize yourself with the gate and all components before you install gate.
| Part No. |
DESCRIPTION |
PRICE EACH |
| PA | Panel Assembly | $14.00 |
| XT1 | Plunger | $1.25 |
| XT2 | Spring | $0.75 |
| XT3 | Blue Carpet Foot | $0.75 |
| XT4 | Screw - #8 x 1 1/2" | $0.15 |
| XT5 | Carrying Strap | $2.25 |
| EX 8662 | Extension Kit | $26.95 |
Pricing in U.S. Currency.
| Instructions
Your Superyard XT is completely assembled at our factory. To make an enclosure, unsnap the carrying strap, and unfold the panels to create a hexagon shape (figure 1). When done unfolding the panels, the two unconnected panels will be oriented as shown in figure 2. Make sure that the blue carpet "foot" is up. To connect the panels together, lift up on panel 1 and set opening "A" over pin "B" (figure 3). Locate the slot on the lower end of cylinder "D". This slot tapers to an opening that pin "C" fits into. To fit pin "C" into this opening, gently press down on panel 1 and align pin "C" wit the end of the slot in the cylinder "D". While maintaining downward pressure on panel 1, lift slightly on panel 2 and slide pin "C" along the slot and into the opening (figure 4).
To Open Enclosure To disconnect two adjoining panels, select one of the three corners where the blue carpet "foot" is facing up. Gently press down on panel 1, and while lifting up on panel 2, slide pin "C" clear of cylinder "D". Then, lift on panel 1 until opening "A" has cleared pin "B".
Folding and Storage Your enclosure is designed to fold compactly. However, it must be folded in sequence. Start at one panel, fold to the next panel making sure that you fold it the correct direction as shown (see figure 6).
Replacing a Panel A broken panel can easily be replaced. Just unlatch and remove broken panel (see instructions for opening enclosures).
Your Enclosure as a Barrier Your enclosure does not have the strength to resist pressure if used in a "straight" position. Be sure that it is not positioned in a straight line. Make sure that each panel is at an angle to the adjoining panel (figure 7).
Cleaning Instructions Your enclosure is made from durable weather-resistant plastic panels. To clean, wash with a mild detergent, rinse with clean water and allow to dry thoroughly.
Extension Kit A two panel extension kit, Model No. 8662, is available from your dealer or from the factory. The kit contains two panels which allow you to increase the size of your enclosure from 18.5 square feet to 34.4 square feet.
|
|
 WARNING |
|
|
|
